Articles Blog

How to Replace a Tumble Dryer NTC (Beko)

How to Replace a Tumble Dryer NTC (Beko)


Welcome to BuySpares In this video we’ll be showing you how to replace
the temperature sensor NTC on this Beko dryer. Important: Before replacing a part
in any electrical appliance you must ensure that the appliance
is first disconnected from the mains A faulty sensor may result in your dryer not heating
but make sure you have checked the heater and it’s thermostat before suspecting
an NTC has failed and need replacing. Open the condenser door and remove this grill
by taking out the two screws holding it on. Disconnect the NTC and pull it from the duct. Using a multimeter you can check the NTC
by measuring across the contacts the resistance will vary
depending on the room temperature. Fit the new NTC into position and connect the plug. Refit the vent grill and it screws. Run a test cycle after the repair if required. For all the spares you need
visit the BuySpares website.

Leave a Reply

Your email address will not be published. Required fields are marked *