Articles Blog

Zanussi Tumble Dryer Belt Replacement

Zanussi Tumble Dryer Belt Replacement


Welcome to Buyspares. In this video we will show how to change
a drive belt in a Zanussi tumble dryer. Important: before replacing a part
in any electrical appliance you must ensure that the appliance
is first disconnected from the mains. A broken drive belt will cause your machine
to not move the clothes and not dry correctly although your dryer may appear to be running,
so you will need to replace it. Start by removing the top panel, Remove the broken belt. Then remove the side panel
by undoing these screws. Remove the other side panel
by taking out these screws. And take off both side panels Take off the fan cover by removing this screw, And prising here. Remove the nut and washer from the spindle
while holding the fan and then push the fan off. Remove the heater cover. Take out the screws
holding the back to the base. Carefully ease the drum away from the front. Pass the belt over the drum lip
and along the drum, then lift and refit the drum onto the drum support
and refit the back screws. Refit the heater covers. Release the tension spring on the motor. And slip the new belt over the spindle. And lift it on to the tension pulley. Turn the motor to refit the belt. Then reconnect the tension spring. Turn the drum to settle the belt, then refit the fan and its cover. Refit the cabinet’s parts
and run a test cycle if required. For all the spares you need
visit the BuySpares website.

Leave a Reply

Your email address will not be published. Required fields are marked *